A cordless drill is a must tool for the boatowner. No shorepower cord needed. I fit them with paint mixers, use them for making repairs, installing accessories, attach sanding disks, polishing pads....it's my most used power tool. But my while my trusty 14-year old 12-volt
Makita still works like a champ, batteries for this veteran are now hard to come by. Sure I can get them on
EBAY, or I could
repack the cells. But since I have a couple other drills, I decided to make a boat-specific drill instead. Since this model is 12-volts, all I had to do was make a wiring harness to connect to my boats DC power supply. Here's how I did it, in about an hour, using scavenged parts from the nooks and crannies of my shop.
Step 1: I stripped both ends of a 12-foot length of
ANCOR MARINE 16-gauge duplex boat cable. Duplex has both the (+) and (-) tin-plated conductors already wrapped in a jacket. Its my preffered wire for any boat work because of the tin-plated corrosion resistance-- and its rated fire-resistant to 105 F. I crimped -on spade connectors that mated to the battery contact plates inside the drill on one end of the cable; on the other end, I wired a
Marinco SeaLink 12-v plug. I like these Sea Link plugs as they are locking, have an LED
on indicator, and are O-ring sealed. I have used them for over a decade and they work great--in fact this one here is scavenged from an old spotlight on which I replaced the cheapo factory plug. The light finally died after 8 years of use. It lived on three boats, but the Sea Link plug is still like new. So I cut it off, chucked in a coffee can of spare parts about a year ago, where it resided( preserved in sawdust) and re-used it here. In Part 2, I'll show you how to wire this plug.
Click Here for PART 2
OK, now that I've got two coats of paint on the interior, I dry-fit my inwales. I clamped them along the spacer blocks and then used my shop-made bevel gauge, a'la Greg Rossel to take and mark the angles on the inwale stock. (Store-bought bevel gauges are too big for the tight confines of smal boats. This one, made from an old hacksaw blade and a rivet is "just right.")I'm happy with how these cuts came out and will now remove the inwales, soak them and clamp them in place. When they dry they will be pre-bent and ready for glue and fasteners.
